© Panduit Corp. 2022
FS132D
5
Rev 05
Step 2:
Clean both ends of the launch
cord before loading it onto the tool.
Note:
Remove the adapter and alignment sleeve from
the cord to properly clean the ferrule.
Tip
: Clean the launch cord every 50 terminations for
optimal tool performance.
DO NOT
use pre-saturated
wipes.
Step 3:
Clean the connector, then load
the connector into the appropriate
adapter and cradle.
Tip:
If the tube is protruding from the rear of an LC
connector, it is not properly seated in the adapter. Rotate
the connector slightly until it can be locked in without the
insertion tube sticking out of the connector. (below)
Tip:
Make sure the alignment tab under the ferrule aligns
with the guide on the cradle for ST terminations. (below)
LC Connector:
SC Connector:
ST Connector:
Step 4:
Slide the boot onto the cable,
narrow end first, then push it back out
of the way. Use the appropriate
Stripping Template to make a strip
mark and an insertion mark on the
buffer.
