23
22
User manual
Pandora DXL-0100L/0101L service-security system
Engine
temperature sensor
Aerial 2,4 GHz
1
2
3
4
5
6
7
8
Yellow
Black
Red
White
Blue
Brown/Red
Green
Brown
(–)
(–)
(+) Fuse 3A
3..100V min 8Hz
(+) 2A
20A max
(–) 200mA
20A max
RHM • FRONT HOOD SWITCH
GROUND
POWER +12V
TACHOMETER
SIREN
BLOCKING RELAY NC
RHM • CODED OUTPUT
BLOCKING RELAY NC
WARNING!!!
Place radio module unit wires down! When installing the device, avoid shielding of built-in 2,4 GHz aerial by metal parts
of the car body (no less than 3 cm from metal surfaces).
Wire 1 (Yellow) is input of front hood limit switch. RHM input (front hood trigger) can operate
in accordance with selected logic in the ‘input table’ of the system (control of glow plugs, generator
charge lamp and etc.).
Wire 2 (Black) is ground, this wire should be connected to the car body in a grounding spot or to
a reliable conductor, connecting car body or to any grounded device. The wire should be connected
FIRST during installation.
Wire 3 (Red) is power supply 12V, this wire connects to any wire that has constant voltage of 12V.
The circuit should be protected by a fuse (3A). If this condition is not satisfied, device can be damaged
and it can impact the security features of the system.
Wire 4 (White) is analog tachometer input, this wire should be connected to wire of tachometer
or signal wire of injector, a wire with stable impulses of any polarity that correspond with motor shaft
rotation frequency.
Wire 5 (Blue) is a siren, this wire connects to siren control wire (+) (maximum load current is 2A).
Wire 6 (Brown/Red) and 8 (Brown) are normally closed relay outputs, maximum load current is
20A, can be used as engine blocking relays. Engine blocking is carried out taking built-in accelerometer
data into account.
Wire 7 (Green) is coded output (channel), maximum load current is 200mA, used to control
additional devices (e.g. HM-05). The output works via programmed logic of ‘Block of timer channels
10(K)’ section in AlarmStudio. In case additional front hood module HM-05 is being programmed,
‘Block of timer channels 10(K)’ should be switched on/off. When front hood lock is controlled, engine
compartment module RHM-02 take into account the status of the hood trigger via its own input or
via any input of the system.
Programming mode (recording) of RHM-02 module
1. Enter the programming mode on the level 5.
2. Wire 7 (OUT-RHM/programming) of RHM-02 module connects to wire 2 (ground) and connects
with a grounded spot of the car.
3. After wire 3 is connected (module power 12V), the system will confirm recording of the module
to the system’s memory with 1 beep of the siren.
4. Disconnect the programming wire 7 from wire 2 and insulate the wires.
