58
10. Similarly, to copy photos from your computer to your memory card, copy and paste to the disk
drive corresponding to the memory card.
IMPORTANT
: If your PC is connected to Local Area Network drives, or if you have multiple drive
letters already assigned to peripheral devices, you will need to manage your drive
settings in Windows to free up the four drive letters immediately following your CD-
ROM drive so the KTC can assign them to memory card slots properly.
Disconnect the KTC from the Computer
It is important to always perform a PC ‘release’ before disconnecting the KTC USB cable from the PC.
WARNING
: Do not unplug or switch off the KTC when files are being transferred between the PC
and KTC, as that can seriously damage the memory.
1. In Windows XP, left-click on the icon and click ‘Remove Hardware Safely’.
2. Select the storage device corresponding with the KTC, and then click
Stop
to disconnect. A final
dialog box opens.
3. Click
Close
. When the
message “It is now Safe to Disconnect Hardware”
appears, you can
disconnect the USB cable from your computer.
Wireless Connection between the KTC and Windows Computer
The
Pandigital DPF Manager Widget
allows you to communicate wirelessly with the KTC and other
Pandigital DPFs to transfer photos between the PC and the internal memory in Pandigital units.
IMPORTANT
: This step assumes your PC is already connected to an active wireless network and that the
KTC is located within a close enough range to make a successful connection to the network.
Setting up the
Pandigital DPF Manager Widget
to transfer photos from your PC to the KTC requires 3 steps:
A. Set up your Wireless Network User ID and Password on the KTC.
(Refer to instructions on page 54)
B. Download and install the Yahoo Widget Engine (Starter Pack) on your PC.
C. Download and install the Pandigital DPF Manager Widget on your PC
(System requirements: Apple MAC or PC with Windows XP or Vista, USB2.0 ports)
Download and Install the Yahoo Widget on your PC
1. Download the Yahoo Widget Engine to your PC; go to
http://widgets.yahoo.com
, click the ‘Get Started
Now’ link, and then download the Starter Pack.
2. Double-click the downloaded setup file to begin installation, then follow the on-screen prompts to
complete the installation.
Download and Install the DPF Manager Widget on your PC
You will need the wireless network IP address later in this installation, so begin by retrieving it by
following these steps:
a) With the KTC in DPF mode and the HOME screen displayed, press
SETUP
.
b) Use the arrows to highlight
NETWORK SETUP
, and then press
ENTER
.
c) Make note of the IP address.
