34
DIGITAL PHOTO FRAME (DPF) SECTION
WARNING: The first time you power the KTC on, you may receive the following
messages:
‘Proceed with Auto Scan’, ‘No Database’, or ‘No Signal’
Because the KTC defaults to the TV mode when shipped from the factory,
if you are not
connected to digital cable
, the first time you power the KTC on, the unit may display
‘
Proceed with Auto Scan
’, ‘
No Signal
’, and/or ‘
No Database
’ messages. Press
SOURCE
on the remote control or side panel buttons, use the arrows to highlight
DPF
, and then press
ENTER
. The KTC will now be in the Digital Photo Frame (DPF) mode, and will remain in the
DPF mode until you change the SOURCE at a later time.
The PanTouch Interface
The KTC includes our PanTouch Technology (active in DPF mode only), a touch icon-driven menu system
designed to provide the same KTC functions as the remote control. The menu icons are conveniently hidden
away in the top right inside edge of the frame waiting to be activated.
TIP
: Throughout this section, (PT) is noted next to instructions referencing specific use of the
PanTouch interface.
Use the PanTouch Interface
Simply touch the
frame
in the area shown in the example below to activate the PanTouch interface.
Note
:
The remote control is disabled when the PanTouch interface is active.
The PanTouch interface will automatically shut off when left idle approximately 3 seconds.
