• 24 V AC power supply connector kit (accessory)
Recommended specification of cable (wire)
AWG size
(stranded
wire)
#24
(0.22 mm
2
)
#22
(0.33 mm
2
)
#20
(0.52 mm
2
)
#18
(0.83 mm
2
)
Length of
cable
20 m
{65.62 feet}
30 m
{98.43 feet}
45 m
{147.64 feet}
75 m
{246.06 feet}
Power supply connector housing (accessory)
Pin No.
Signal
1
2
3
4
24 V AC LIVE (Brown)
24 V AC NEUTRAL (Blue)
Ground (Green)
Not use
• How to assemble the 24 V AC power supply con
-
nector kit
Remove approx. 3 mm {1/8 inches} of the outer jacket of
the cable and twist the cable core to prevent the short cir-
cuit first.
Insert the tip of the cable into the point A of the contact
(accessory), and hold the cable using the cable clamp.
Procure either of the following tools for clamping.
Molex manual clamp tool:
57027-5000 (for UL1015), 57026-5000 (for UL1007)
After clamping the contact (accessory) and the cable,
insert the contact properly into the power supply connec-
tor housing (accessory).
IMPORTANT:
• Conduct the electric conduit work after processing
the power supply connector and making sure that the
camera is operating normally.
• Network cable
Connect a LAN cable (category 5e or better) to the net-
work connector.
IMPORTANT:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m {328
feet}.
• Make sure that the PoE+ device in use is compliant
with IEEE802.3at standard.
• When connecting both of the 24 V AC power supply
and the PoE+ device for power supply, 24 V AC will
be used for power supply.
* If a 24 V AC power supply and a PoE+ hub or router
are used at the same time, network connections may
not be possible. In this case, disable the PoE+ set-
tings. Refer to the operating instructions of the PoE+
hub or router in use.
* Depending on the PoE+ device used, if you stop the
24 V AC power supply after operating it and a PoE+
hub or router at the same time, the power supply may
stop, causing the camera to restart.
• When disconnecting the LAN cable once, reconnect
the cable after around 2 seconds. When the cable is
quickly connected, the power may not be supplied
from the PoE+ device.
• Output cable for the monitor used for adjustment
Connect a coaxial cable (BNC) (only for checking if images
are displayed on the monitor).
This output is provided only for checking the adjustment
of the angular field of view on the video monitor when
installing the camera or when servicing.
IMPORTANT:
• The monitor out connector for adjustment is provided
only for checking the adjustment of the angular field
of view on the monitor used for adjustment when
installing the camera or when servicing. It is not pro-
vided for recording/monitoring use.
• Black bands may appear at the top and bottom or
right and left of the screen. (That does not affect the
adjustment because the angular field of view is not
changed.)
Contact
(accessory)
Insert
Upper
side
A
Approx. 3 mm {1/8 inches}
Cable
Contact (accessory)
Power supply connector housing (accessory)
Upper side
Cable
27
