Step 7
Fix the front and rear sunshields on the camera using the
front/rear sunshields fixing screw (accessory).
(Recommended tightening torque: 0.72 N·m {0.53 lbf·ft})
Front/rear sunshields fixing screw
Note:
• When removing the front and rear sunshields, perform
steps 5 - 7 in the reverse order. (
☞
pages 24 and 25)
Precautions
• The rain wash coating is applied to the surface of the dome cover. Do not directly touch the surface of the dome
cover or wipe it with a cloth or other product. Also, prevent sweat dropping on or spitting on the cover. Failure to
observe this may reduce the effectiveness of the rain wash coating.
• When cleaning the dome cover, wash away any dirt or other unwanted substances by pouring or spraying clean
water from a hose or spray bottle
*1
(do not wipe the dome cover with a cloth or other product). Do not use benzine,
thinner, alcohol, or any other types of solvents or detergents.
• Improper cleaning of the dome cover may cause the rain wash coating
to become less effective. In this case, in order to have effective rain wash
coating, a new dome cover must be purchased to replace the existing
dome cover. Consult with your dealer.
• Attach the “Caution label” carried by the camera to the surface of the
production (Refer to the illustration).
Protection Cover
PGKV1116
*1 Note that foreign objects may be mixed into water depending on the container, and it may result in reducing the
effectiveness of the rain wash coating. Do not use the spray bottle equipped with a handle or a function to adjust
the way of spraying, since the lubricant agent may be mixed into water.
Step 8
After the installation is completed, remove the tape
wrapped around the camera while holding the Protection
Cover, and then take off the Protection Cover.
Tape
Camera
Dome cover
Protection Cover
25
