![background image](http://html1.mh-extra.com/html/panasonic/wv-bs300/wv-bs300_operating-instruction_4215164011.webp)
- 8 -
(6) Synchronization (SYNC)
Important Notice:
The priority of sync mode is as follows:
1. Multiplexed Vertical Drive (VD2) (Highest)
2. Line-lock (LL)
3. Internal Sync (INT) (Lowest)
Note:
The automatic sync mode selection is made according to priority listed above. Refer to
"Synchronization Setting" on page 12 for detailed procedures.
(7) Special Menu (SPECIAL)
Aperture level, and pedestal level can be adjusted. Your settings can
be released to return to the default settings.
See page 15 for the settings.
* SPECIAL *
AP GAIN ....I....
PEDESTAL .I.......
−
+
CAMERA RESET
→
PUSH SW
RET
(8) Automatic Panning (AUTO PAN)
Select one of the two panning modes below:
OFF
:
Operates the panning manually.
AUTO PAN :
Operates the panning automatically with the preset
panning range.
** SET UP **
CAMERA ID OFF *
ALC/MANUAL ALC *
SHUTTER OFF
AGC ON
SYNC INT
AUTO PAN OFF
SPECIAL *
■
MENU DISPLAY
●
Setup Menu Display
1. Select the desired camera number to set up and a monitor to display
the setup menu.
2. Display the D4 menu by using the cursor.
3. Press the F1 button.
The setup menu appears on the monitor.
4. To close the setup menu, press the F4 button.
D4 menu
■
Setting Procedures
The following setting procedures are described on the assumption that this model is used in combination with
the WJ-SX550A Matrix Switcher and WV-CU550A System Controller. If this model is used with WV-RM70
System Controller, refer to "In Case of WV-RM70" on page 5 for operation.
F 1
F 2
F 3
F 4
Camera Set up menu
Res A.Res EXIT
F 2
F 3
F 4
Camera Set up menu
On EXIT
F 1
Summary of Contents for WV-BS300
Page 3: ......