-47-
RESET
SPOT
■
Alarm Suspension
This function disables activation of the alarm link
and instead enables recording of any alarm activat-
ed in the alarm log.
It is used to suspend the alarm link during camera
setup.
1. Press the
RESET
and
SPOT
buttons simultaneously
for more than two seconds to suspend the alarm.
The LED on the RESET button lights up.
2. Press the
RESET
button again to reset the alarm
suspension.
The LED on the RESET button goes off.
OTHER FUNCTIONS
■
Recording on the Time
Lapse VTR
The following selections are made on the SETUP
MENU described previously.
Refer to the Recording Mode Setting on page 28 for
more details.
1. Check the selected recording mode (MODE 0 -
MODE 9).
MODE 0:
Normal Mode (Real Time)
MODE 1 - 9:
Time Lapse Mode (Linear Mode)
If MODE 9 is selected, check the picture (Spot or
Quad) to be recorded on the VTR.
2. Press the Record button of the VTR to begin record-
ing.
Notes:
• While recording with the camera switching
pulse (MODE 9), quad recording will work
properly when the selected recording interval is
more than 0.13 seconds (less than 8 fields/s).
• While recording without the camera switching
pulse (MODE 1-8), quad recording is not avail-
able.
When useing a VTR whose recording interval is
2 or 3 fields, select 4 fields (minimum) for the
REC MODE parameter.
However the same picture may be recorded
repeatedly.
■
Camera Switching Pulse
Loss Display
• When loss of the camera switching pulse isdetect-
ed, “SW LOSS” will flash on the monitor screen.
• The buzzer does not beep.
• When the camera switching pulse is recovered,
“SW LOSS” is cleared from the monitor.
Notes:
• When MODE 0 to MODE 8 is selected for
recording, or MULTI 2 OUT for REC OUT, “SW
LOSS” is not displayed because of the way the
system application works.
• If “ALARM” or “CH
PP
LOSS” is displayed on
the monitor screen, “SW LOSS” is not displayed
because alarm has priority.
