Panasonic WJFS616 - SWITCHER, Service Manual

Page: 4 / 41

1
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
4
8
12
16
3
7
11
15
2
6
10
14
1
5
9
13
PUSH OPEN
16
POWER
LOCK
ON
OFF
ALARM
MULTI
SCREEN
MULTISCREEN
SELECT
RESET SPOT SEQUENCE
VTR
CAM
CAMERA/PRESET POSITION
FUNCTION
PRE-POSI
LEFT
RIGHT
AUTO
UP
DOWN
HOME/SET
EL-ZOOM STILL
CURSOR / CAMERA CONTOROL
CLOSE OPEN
I R I S
NEAR FAR
FOCUS
TELE WIDE
ZOOM
LOCK
OFF ON
SET UP/ESC
VTR CONTROL
T/L MODE
/ /
<Front View>
1. Power Switch (POWER ON / OFF)
This switch turns the power of the video multiplexer on
or off. The LED (Red) lights up when the power is
turned on.
Caution: The LED indicator blinks to indicate an abnor-
mality of the cooling fan in this appliance.
Turn the power off and refer servicing to qualified
service personnel.
Note: To prevent that the power of the video multiplexer
is turned off accidentally, install the supplied switch
protector.
2. Lock Indicator (LOCK)
This LED (Yellow) indicator lights up to indicate that the
LOCK switch is in ON position.
While this LED is lit, control from the video multiplexer is
disabled.
3. Alarm Reset Button (ALARM RESET)
This button is used to cancel an active alarm. Press this
button, while the alarm function is activated, to reset the
alarm and return the system to the condition before the
alarm function was activated.
The LED (Orange) in the button lights up to indicate that
the alarm suspension mode is selected.
4. Alarm Indicator (ALARM)
This LED (Red) indicator blinks to indicate an alarm
condition exists.
It changes to steady light when the alarm is reset auto-
matically.
To turn the indicator off, press the ALARM RESET but-
ton.
5. Spot Monitor Button (SPOT)
This button is used to operate the spot monitor connect-
ed to the SPOT OUT connector.
The LED (Green) in the button lights up to indicate that
the spot monitor is selected.
6. Multiscreen Monitor Button (MULTISCREEN)
This button is used to operate the multiscreen monitor
connected to the MULTISCREEN connector.
The LED (Green) in the button lights up to indicate that
the multiscreen monitor is selected.
Note: When REC OUT is used as Multiscreen 2 Output,
this button alternately selects multiscreen output or
multiscreen 2 output.
The LED blinks to indicate that the multiscreen 2
output is selected.