54
55
Configure the Panasonic alarm protocol settings
[Panasonic alarm protocol]
The settings to notify the PC of the event and error information when an event or an error occurs can be config-
ured on this tab.
To display the event and error information, it is necessary that the software (option) is installed on the recipient
PC.
Refer to the "readme.txt" on the provided CD-ROM for details on the software.
[Port number(to PC)]
Enter the port number of the recipient PCs.
It is usually not necessary change the default.
Default:
1818
[Retry]
Set the number of retry attempts for the transmission
to the PC.
0 - 8 (times) (In steps of times)
Default:
2
Note:
• If the transmission to the PC fails, increase the
number of retry attempts.
[Destination address - Address1 - Address8]
Enter the addresses of the recipient PCs. Enter the IP
address or host name for "Address1" - "Address8".
The host name is available only when "Manual" is
selected for "DNS" on the [Basic] tab accessed from
the "Advanced setup" menu - the "Network" page of
the setup menu.
Up to 8 destination addresses can be registered.
Enter up to 255 alphanumeric characters including
hyphens (-) and periods (.).
[Setup via recorder's main monitor]
