Scanning
21
1
Us
ing
The unit is capable of producing about 15 more
copies when the Remaining Film Indicator begins to
flash. The unit has run out of thermal transfer film
and can no longer make copies when the Display
Window flashes “
”. Separately available
replacement film may be purchased from the dealer
where you purchased the unit. Thermal transfer film
is replaced as follows.
1
Push down the printer open lever to
open the printer door, and remove
the used film.
2
Refer to steps 3 and 4 in the section
of “Installing the Thermal Transfer
Film” on page 18.
Notice
•
If “
” is still flashing after closing
the printer door, make sure that the thermal
transfer film has been installed properly and
tightened.
•
The printer door should be closed to make
copies properly. Confirm both latches are
locked.
Replacing the Thermal
Transfer Film
Notes on Replacing Thermal Transfer
Film
•
Only use the designated product (UG-6001) as
the replacement film. (Note that using another
type of replacement film may result in a loss in
printing quality or in damage to the unit.)
•
Thermal transfer film is disposable. Dispose of
used thermal transfer film as “burnable” or
“non-recyclable” rubbish.
•
A negative of the copied image will remain on
the thermal transfer film. To protect the
security of your information, we recommend
cutting up the used thermal transfer film with
scissors or shredder before disposing of it.
•
When replacing the thermal transfer film,
clean the film gear installation part.
Printer open
lever
UB-5335&5835&5365&5865-PNQX5932ZA-mst.book 21 ページ ２０１２年１１月１２日 月曜日 午前９時４２分
