Panasonic U-4..6ML5XPQ, Service Manual

Page: 112 / 283

Field Setting
100 Test Operation
3.1.7 Centralized Control Group No. Setting
CZ-02RT11P Type In order to conduct the central remote control using the central remote controller and the unified
ON/OFF controller, Group No. settings should be made by group using the operating remote
controller.
Make Group No. settings for central remote control using the operating remote controller.
1. Turn ON the power of the indoor unit and unified ON/OFF controller. (Unless the power is
ON, no setting can be made.)
Check that the installation and electrical wiring are correct before turning the power supply ON.
When the power supply is turned ON, all LCD appear once and the unit may not accept the
operation for about one minute with the display of “
”
flashing (an interval of ON, ON,
and OFF)
2. While in normal mode, press and hold the “ ” switch for a period of four seconds or
more to set the system to "Field Setting Mode".
3. Select the MODE No. “
00
” with the “ ” button.
4. Use the “ ” button to select the group No. for each group.
(Group numbers increase in the order of 1-00, 1-01, ... 1-15, 2-00, ... 4-15.)
5. Press “ ” to set the selected group No.
6. Press “ ” to return to the NORMAL MODE.
Note:
„
For wireless remote controller, see the following.
„
For setting group No. of HRV and wiring adaptor for other air conditioners, etc., refer to the
instruction manual attached.
NOTICE
Enter the group No. and installation place of the indoor unit into the attached installation table.
Be sure to keep the installation table with the operation manual for maintenance.
SETTING
TEST
UNIT NO.
5
2,6
4
3
GROUP NO.
MODE NO.
FIELD SET
MODE
Urban Multi ML5 · Mini UM · Heat Pump