63
Adjusting Pos./Size
H-position
Adjust the horizontal position.
V-position
Adjust the vertical position.
H-size
Adjust the horizontal size.
V-size
Adjust the vertical size.
Dot clock (During Component/PC input signal)
Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this
happens, adjust so that any such noise is minimized.
Clock
phase
(During Component/PC input signal)
Eliminate the flickering and distortion.
Over scan
Turn image over scan On/Off.
Configurable signals are as follows:
525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, RGB, DVI-D, SDI, HDMI)
On
Off
Notes:
•
When “Off” is set, “H-size” and “V-size” cannot be adjusted.
•
When the “Display size” is set to “On” in the Options menu, this setting will be invalid. (see page 90)
Notes:
•
If the dot clock frequency of an analog signal is 162 MHz or higher, “Dot clock” and “Clock phase”
cannot be automatically corrected.
•
When digital signal input, Dot clock and Clock phase cannot be made.
•
Auto setup may not work when a cropped or dark image is input. In such case, switch to a bright
image with borders and other objects are clearly shown, and then try auto setup again.
•
Depending on the signal, out of alignment may occur after Auto setup. Carry out fine tuning for the
position/size as required.
•
If Auto setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz,
1280×768@60Hz, and 1366×768@60Hz), pre-selecting the individual signal in “XGA mode” (see
page 86) may results in correct Auto setup.
•
Auto setup does not work well when a signal such as additional information is superimposed out
of valid image period or intervals between synchronizing and image signals are short, or for image
signal with tri-level synchronizing signal added.
•
If Auto setup cannot adjust correctly, select “Normalise” once and press ACTION ( ), then adjust
Pos./Size manually.