1
2
SERIAL
PC IN
AUDIO
SLOT1
SLOT2
SLOT3
P
R
/C
R
/R
P
B
/C
B
/B
Y/G
COMPONENT/RGB IN
LAN
AUDIO
R
L
AUDIO OUT
AUDIO OUT
R
L
AC cord connection (see page 12)
Stereophonic sound code
audio equipment
line-in
AUDIO OUT Terminals connection
8
Connections
– Cable xing band
Secure any excess cables with band as required.
Note:
Two xing bands are supplied with this unit. In case of securing cables at four positions, please purchase it separately.
Pass the attached cable
xing band through the clip
as shown in the gure.
To secure cables connected to Terminals, wrap the cable xing band around them then
pass the pointed end through the locking block, as shown in the gure.
While ensuring there is suf cient slack in cables to minimize stress (especially
in the power cord), rmly bind all cables with the supplied xing band.
To tighten:
To loosen:
Pull
Pull
Push the catch
Note:
Terminal board is installed in SLOT2 and SLOT3 at factory shipment.
Dual HDMI Terminals
(equivalent of Dual HDMI
Terminal Board (TY-
FB10HMD)) (see page 11)
From EXTERNAL
monitor terminal
on Computer
(see page 9)
LAN
Terminal
(see page
60)
COMPONENT/
RGB IN
Terminals
(see page 11)
From SERIAL
Terminal
on Computer
(see page 10)
From input
on audio
ampli er
(see page 8)
Optional
Terminal
Board Insert
Slot (covered)
Note:
Make sure that the
AC cord is locked on both
the left and right sides.
Push until
the hook clicks.
2.
Pull off.
1.
Keep the
knob
pressed.
– AC cord xing
Unplug the AC cord
Unplug the
AC cord
pressing the
two knobs.
Note:
When disconnecting the AC
cord, be absolutely sure to
disconnect the AC cord plug
at the socket outlet rst.
Close
Open
Plug the AC cord into
the display unit.
Plug the AC cord until
it clicks.
Fix the AC cord with
the clamper.
2
1