SLOT3
P
R
/C
R
/R
P
B
/C
B
/B
Y/G
COMPONENT/RGB IN
LAN
AUDIO
60
Using Network Function
This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT” to “LAN”.
(see page 54)
When “LAN” is set, the slot power is turned on, and power indicator is lit orange under the condition of power “Off” with
remote control (stand-by state), regardless of the “Slot power” setting. (see page 57)
Example of Network Connection
Command Control
Notes:
• Lay the LAN cable away from other connection cables (excluding the power cord).
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use “category 5” LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 10)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Hub or broadband router
Display (main unit, rear)
COMPUTER
LAN cable (not supplied)
LAN cable (not supplied)