23
VQT4U56
Others
As a factory preset, this system will always turn off
automatically if there is no sound output and no
operation for approx. 30 minutes.
To cancel this function
1
Press [SETUP] repeatedly to select “AUTO OFF”.
2
Press [
3
,
4
] to select “OFF” and then press [OK].
≥
To turn automatic standby on, select “ON” in step 2.
≥
This setting cannot be selected when “DAB/DAB+” or “FM” is
the source.
≥
When connected to a Bluetooth
®
device, the automatic
standby function does not work.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
1
Press [
, AUX] to select “AUX”.
2
While pressing and holding [SELECTOR] on the
speaker unit, press and hold [CD/RADIO] on the
remote control until this system's displays show
“REMOTE 2”.
3
Press and hold [OK] and [CD/RADIO] on the
remote control for at least 4 seconds.
To change the mode back to “REMOTE 1”, repeat the steps
above but replace the button pressed on the remote control
from [CD/RADIO] to [
, AUX].
Occasionally, Panasonic may release updated
software for this system that may add or improve the
way a feature operates. These updates are available
free of charge.
The CD unit and the speaker unit need to be updated
separately.
Preparation
≥
Turn this system on.
≥
Connect this system to the wireless network. (
l
10)
– Make sure that the wireless network is connected to the
Internet.
– If “D.CONNECT” is set to “ON”, change the setting to
“OFF” and connect this system to a wireless network that
is connected to the Internet.
∫
Updating the CD unit
1
Download the latest firmware from the following
website and burn it to a CD-R to update the
firmware.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
2
Insert the CD-R to the CD unit.
3
Press [CD/RADIO] repeatedly to select “CD”.
4
Press [
3
,
4
] to select “UPDATE? Y” and then
press [OK] to start the update.
≥
Select “UPDATE? N” to cancel the update.
{.
After the update has finished, “SUCCESS” is displayed.
5
Disconnect the AC mains lead and reconnect it
after 3 minutes.
∫
Updating the speaker unit
1
Press [SETUP] repeatedly to select
“SW UPDATE” and then press [OK].
2
Press [
3
,
4
] to select “UPDATE? Y” and then
press [OK] to start the update.
≥
Select “UPDATE? N” to cancel the update.
{.
After the update has finished, “SUCCESS” is displayed.
3
Disconnect the AC mains lead and reconnect it
after 3 minutes.
≥
If there are no updates, “NO NEED” is displayed.
≥
Downloading will require several minutes. It may take
longer or may not work properly depending on the
connection environment.
∫
Checking the software version
1
Press [SETUP] repeatedly to select “SW VER.” and then
press [OK].
{.
The version of the installed software is displayed.
2
Press [OK] to exit.
Automatic standby
Changing the remote control code
Software update
DO NOT DISCONNECT the AC mains lead while
one of the following messages is displayed.
– “LINKING”, “UPDATING” or “
%”
(“
” stands for a number.)
≥
During the update process, no other operations can be
performed.
SC-NE5DB~VQT4U56.book 23 ページ ２０１３年１月２１日 月曜日 午後６時１８分
