Panasonic S-LINK V, User Manual

Page: 171 / 182

171
Appendix
Appendix
Flowchart for error detection
Occurrence of error
The error indicator will light off.
The address display will perform
rotational indication.
Output of error output terminal: OFF
(Low → Hi)
The error indicator will light up.
Transmission will be stopped.
The error number will appear on
the address display.
Eliminate the cause of the error.
5 seconds later, the system will be
automatically reset.
Output of error output terminal: ON
(Hi → Low)
Press the ENTER, , and
buttons at the same time. (Note)
Troubleshooting The error indicator will blink.
If error output is set
Stops the error indicator from blinking.
Erases the error number shown on the address display.
The error num-
ber is still shown
on the address
display.
The error is
automatically eliminated.
Refer to page 166.
2
Yes
Yes
1
No
Error number
1. Error 1 or 2
2. Error 3, 4, or 5
The error is
automatically eliminated.
No
Note: Before following the above procedure, be sure to set the mode selection switch to ‘RUN.’