Panasonic S-LINK V, User Manual

Page: 88 / 182

88
Chapter 4
Specifications
<SL-VVMES2>
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
SW9
SW10
SW11
2
1
9
15
13
11
14
12
10
17 16
3
6
4
7
5
8
No. Designation Function
1
S-LINK V terminal block
connector for port 1
7: F.G.
Use these connectors to connect the power supply and signal lines of the S-LINK V system.
6: + 24V
5: 0V
4: + 24V
3: 0V
2: D
1: G
2
S-LINK V terminal block
connector for port 2
7: F.G.
6: + 24V
5: 0V
4: + 24V
3: 0V
2: D
1: G
3
I/O first address setting
switches
Use these switches to set two upper digits of the first short address of the VME bus (address consists of
4 digits of hexadecimal numbers).
4
Transmission mode set-
ting switches for port 1
I/O control points setting
switches for port 1
Use the transmission mode setting switches to set the transmission mode to A mode, B mode, or C
mode.
Use the I/O control points setting switches to set the number of I/O control points.
Not used
ON
1 2 3 4 5 6 7 8
Transmission mode setting switches
I/O control points setting switches
5
Transmission mode set-
ting switches for port 2
I/O control points setting
switches for port 2
6 I/O setting switches for port 1
Use these switches to set the I/O (for I/O of every 32 points).
7 I/O setting switches for port 2
8 System setting button for port 1
Use this button to read and store the unit connection condition data.
After this, the system will use this data to check for errors 3, 4, and 5.
9 System setting button for port 2
10
Transmission indicator
for port 1 (Green)
This indicator will blink during transmission (when the transmission signal is being output).
The indicator blinking cycle depends on the transmission speed.
11
Transmission indicator
for port 2 (Green)
12
BUSY indicator for port 1
(Orange)
This indicator will light up during system setting operation or transmission check operation.
13
BUSY indicator for port 2
(Orange)
14 Error indicator for port 1 (Red)
This indicator indicates the error status as follows:
• Lights up when an error occurs.
• Blinks when the cause of the error is eliminated.
15 Error indicator for port 2 (Red)
16
Interruption level setting
swithces
Use these switches to set the VME bus interruption level (IRQ1 to IRQ7).
17 Status / ID setting switches
Use these switches to set the status / ID using binary numbers.
The status / ID will be transmitted at VME bus interruption.