Rx450AC Rx550DC MK3 Installation Manual - V19 30Sep05.doc
Page 16/28
4. SETUP
Set the receiver address.
Connect a video monitor to the video output of the receiver marked “J1 To Matrix”.
a) Press any button, SW1, SW2 or SW3 and power up. The RECEIVER MENU will be
displayed and COMMUNICATIONS will be flashing.
Release button and press SW2 (MENU/SET) to enter the COMMUNICATIONS menu.
b) Use SW1 (UP) or SW3 (DOWN) to move to MENU UNLOCK. Press SW2
(MENU/SET) to toggle to UNLOCK.
c) Use SW1 (UP) or SW3 (DOWN) again to move to UNIT ADDRESS and press SW2
(MENU/SET) to display the UNIT ADDRESS screen.
d) Use SW1 (UP) and SW3 (DOWN) until the required address is displayed and press
SW2 (MENU/SET) to select this address and display the previous screen.
e) Use SW1 (UP) or SW3 (DOWN) to move to BAUD RATE and press SW2 (MENU/SET)
to select required baud rate (BBV recommend using 9600 baud – 4 wire).
f) Use SW1 (UP) or SW3 (DOWN) to move to TELEM DATA and press SW2
(MENU/SET) to choose either 2 WIRE or 4 WIRE as required.
g) DELAY TIME can be left at OFF. Please refer to Panasonic equipment manual before
adjusting this.
h) Use SW1 (UP) or SW3 (DOWN) to highlight RETURN and press SW2 (MENU/SET) to
return to previous menu.
i) Use SW1 (UP) or SW3 (DOWN) to highlight RETURN and press SW2 (MENU/SET) to
exit from the menu. The receiver will restart and you can now wire the unit.
Set the lens direction.
After wiring the pan/tilt head and lens it is possible that the lens will drive in the opposite
direction, ie pressing ZOOM TELE will cause the lens to drive out, wide. It is possible to
check if the lens wiring is reversed by navigating to the ENGINEER MODE menu and
selecting ZOOM IN or ZOOM OUT. If the lens drive is reversed then navigate to the
ZOOM FOCUS IRIS screen of the OPTIONS menu and set to REVERSE. It is
recommend that a self test is performed after changing the lens direction otherwise
preset positioning will not work.
DIAGNOSTIC AIDS
A single diagnostic LED labelled POWER provides indication of presence of power and
also data from the multiplexer.
When the receiver is powered, the LED illuminates.
The LED will blink when the receiver has received correct telemetry data with the same
address as the DIP switch address. If the telemetry data is invalid or the data is
addressed to another device, the LED will remain illuminated.
Additional diagnostic aids are available in the receiver’s
MAIN/RECEIVER/DIAGNOSTICS
menu. (see later)
