2-34
T4 Height Plate, Pinch Arm Unit
Fig. DM16
18 T4 Height Plate
Spring
Slide
See Reassemly Notes.
Hooking Portion A
Spring
(S-8)
19 Pinch Arm Unit
Hole
(Through Hole)
Hooking Portion A
Hooking Portion B
T4 Drive Arm
Pin
Pin A
Hole A
Slot
Hooking Portion B
Reassembly Notes:
1. Installation of Pinch Arm Unit, T4 Height Plate
1) Before installing, place the Mechanism in STOP Position
by rotating the Mode Switch counterclockwise fully.
2) Install the Pinch Arm Unit so that Pin of Pinch Arm Unit
is in Slot and that Pin A is inserted to Hole A on Pinch
Arm Unit. (The holes on Pinch Arm Unit are Through
Hole.)
3) Hook the Spring to Hooking Portion A, and then to
Hooking Portion B of T4 Drive Arm.
4) Place the T4 Height Plate on the Pinch Arm Unit, and
then slide it as indicated by the arrow.
Disassembly Notes:
1. When removing the T4 Height Plate, slide it as indicated by
the arrow.
Summary of Contents for PV-DAC10
