4-1
SCHEMATIC DIAGRAMS
SCHEMATIC DIAGRAM AND CIRCUIT BOARD LAYOUT NOTES
1. Important safety notice
Components identified by the sign
have special charac-
teristics important for safety. When replacing any of these
components. Use only the specified parts.
2. Do not use the part number shown on this drawing for or-
dering. The correct part number is shown in the parts list,
and may be slightly different or amended since this draw-
ing was prepared.
3. Use only original replacement parts:
To maintain original function and reliability of repaired units,
use only original replacement parts which are listed with
their part numbers in the parts list section of the service
manual.
4. Parts different in shape or size may be used.
However, only interchangeable parts will be supplied as
service replacement parts.
5. Test point information
:Test point with a no test pin.
Schematic Diagram Notes
1. Indication for Zener Voltage of Zener Diodes
The Zener Voltage of Zener Diodes are indicated as such
on Schematic Diagrams.
Example:
(6.2V)......Zener Voltage
2. How to identify Connectors
Each connector is labeled with a Connector No. and Pin No.
Indicating what it is connected to, in other words, its counter
part.
Use the interconnection schematic diagram to find the
connection between associated connectors.
Example:
The connections between C.B.A.s are shown below.
MAIN C.B.A.
RELAY C.B.A.
The Number of pins of the Connector.
Connector No. on Main C.B.A.
P2
P9001
E64 (13 Pins)
Ref. No. of the connection parts such as lead cable,
flexible cable which is supplied as a replacement parts.
3. Parts enclosed in dashed lines marked “Z” are not used in
any models included in this service manual.
Example:
R3002
10K
C3010
0.01
Z
Comparison chart of models & marks
Signal Waveform Note
How to read Signal Waveform
Voltage Chart Note
Voltage Measurement
a. Color bar signal in SP mode.
b. ---:Unmeasurable or not necessary to measure.
Circuit Board Layout Note
Circuit Board Layout shows components installed for
various models.
For proper parts content for the model you are servicing,
please refer to the schematic diagram and parts list.
PIN1 OF IC3001
0.5V
REC
20µs
WF5
1
2
3
4
5
1
Connecting Point
2
Volts/Div
3
Operation Mode of
VCR
4
Time/Div
5
Waveform Point on
Schematic
Note:
Refer to item 3 of Schematic Diagram Notes for mark “Z”.
PV-DV100
PV-DV200
PV-DV400
PV-DV600
Not Used
A
B
C
D
Z
MODEL
MARK
Summary of Contents for PV-DAC10
