Chapter 1
Preparation — Precautions for use
28 - ENGLISH
f
Illegally accessed
A malicious third party may access your personal or corporate network without authorization and engage in the
following types of behavior.
g
Retrieve personal and/or secret information (information leak)
g
Spread false information by impersonating a particular person (spoofing)
g
Overwrite intercepted communications and issue false data (tampering)
g
Spread harmful software such as a computer virus and crash your data and/or system (system crash)
Since most wireless LAN adapters or access points are equipped with security features to take care of these
problems, you can reduce the possibility of these problems occurring when using this product by making the
appropriate security settings for the wireless LAN device.
Some wireless LAN devices may not be set for security immediately after purchase. To decrease the possibility
of occurrence of security problems, be sure to make all security related settings according to the operation
instructions supplied with each wireless LAN device before using a wireless LAN device.
Depending on the specifications of the wireless LAN, a malicious third party may be able to break security settings
by special means.
Panasonic Connect Co., Ltd. asks customers to thoroughly understand the risk of using this product without
making security settings, and recommends that the customers make security settings at their own discretion and
responsibility.
Notes regarding the wireless LAN
Radio wave in the 2.4 GHz band is used when the wireless LAN connection function of the projector is used. The
license of wireless station is not required, but understand the following when using.
To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module (Model
No.: AJ-WM50 Series).
r
Do not use close to other wireless devices.
Following devices may be using radio wave in the same bandwidth as the projector. Using the projector close to
these devices may cause the communication to be disabled or the communication speed to slow down due to
interference of radio wave.
f
Microwave oven, etc.
f
Industrial, scientific, or medical devices, etc.
f
In-plant wireless station for identifying moving vehicles used in the manufacturing lines at a plant
f
Specified low power wireless station
r
Do not use cell phone, television, or radio as much as possible close to the projector.
Cell phone, television, or radio is using radio wave with different bandwidth from the projector, so there is no effect
on the wireless LAN communication or the send/receive on these devices. However, noise may occur in the audio
or video due to the radio wave from the projector.
r
Radio wave for wireless LAN communication does not go through the reinforcing
bars, metal, or concrete.
The projector can communicate through wall or floor made of wood or glass (excluding the glass with metal mesh
embedded), but it cannot communicate through wall or floor made of reinforcing bars, metal, or concrete.
r
Do not use the projector as much as possible in a location where static electricity is
generated.
The communication via wireless LAN or wired LAN may be prone to disruption when the projector is used in a
location where static electricity or noise is generated.
There is a rare case that the LAN connection may not be established due to static electricity or noise, so in such
case, turn off the projector, remove the source of problematic static electricity or noise, and turn the projector back
on.
Slot
This projector is equipped with Intel
®
Smart Display Module (Intel
®
SDM) specification slot.
Optional Function Board or an interface board or module of other manufacturers supporting Intel
®
SDM Small
(Intel
®
SDM-S) or Intel
®
SDM Large (Intel
®
SDM-L) specification (collectively referred to as “Function Board”
hereinafter) can be installed in the slot. For the devices of other manufacturers that the operation has been
verified with this projector, visit the following website.
https://panasonic.net/cns/projector/
