About your projector
Remote control
2
1
3
5
10
11
19
4
4
20
6
7
8
9
18
15
16
17
12
13
14
1 Power <
v
/
b
> button
(
v
: Standby,
b
: Power on)
Sets the projector to the state where the projector is switched
off (standby mode). Also starts projection when the power is
switched off (standby mode).
2 Input selection buttons (
<HDMI1>, <HDMI2>,
<COMPUTER1/2>,
<NETWORK/USB>)
Switches the input signal to project. (
x
page 51)
3 <MENU> button/<RETURN> button / <ENTER> button/
asqw
buttons
Used to navigate through the menu screen. (
x
page 61)
asqw
buttons are also used to enter the password in
[SECURITY] or enter characters.
4 <VOL-> button/<VOL+> button
Adjusts the volume of the built-in speaker or audio output.
(
x
page 54)
5 <SCREEN ADJ> button
You can extend the projection distance via the Digital Zoom
Extender function or correct various types of distortion in a
projected image. (
x
page 55)
6 <FREEZE> button
Used when pausing the image and turning off the audio.
(
x
page 55)
7 <P-TIMER> button
Operates the presentation timer function. (
x
page 57)
8 <D.ZOOM +> button / <D.ZOOM -> button
Zoom in and out the images. (
x
page 56)
9 Remote control signal transmitter
10 <AUTO SETUP> button
Used to automatically adjust with auto setup function while
projecting the image. (
x
page 55)
11 <CEC> button
Displays the HDMI-CEC operation screen. (
x
page 93)
12 <SHUTTER> button
Used to turn off the audio and video temporarily. (
x
page 54)
13 <MUTE> button
Used to temporarily mute the projector. (
x
page 54)
14 <STATUS> button
Displays the projector information. (
x
page 58)
15 <ASPECT> button
Switches the aspect ratio of the image. (
x
page 57)
16 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(
x
page 62)
17 Number (<0> ~ <9>) buttons
Used for entering a password or an ID number in a multiple
projector environment.
18 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(
x
page 57)
19 <ID ALL> button
Used to simultaneously control all the projectors with a single
remote control in a multi-projector environment. (
x
page 58)
20 <ID SET> button
Sets the ID number of the remote control in a multi-projector
environment. (
x
page 58)
Attention
f
Do not drop the remote control.
f
Avoid contact with liquids or moisture.
f
Do not attempt to modify or disassemble the remote control.
f
Please observe the following contents that are described on the back of the remote control unit (see the picture below).
g
Do not use a new battery together with an old battery.
g
Do not use unspecified batteries.
g
Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the “Read this first!”.
ENGLISH
-
27
Chapter 1 Preparation - About your projector
