ENGLISH - 19
Installation (continued)
Changing the orientation of the main unit of the projector
This section describes changing the orientation of the main unit of the projector to make the installation work
much easier.
Ball joint fixing screw
Ball joint stopper
1) Place the projector on a cloth or the like that
has been laid on a flat surface.
2) Loosen the ball joint fixing screw.
z
Loosen the ball joint fixing screw of the
projector with the allen wrench (5.0 mm (3/16ʺ)
across flats) supplied with the projector.
Shaft holder
Main unit
3) Change the orientation of the main unit.
z
Loosening the ball joint fixing screw enables
rotation of the shaft holder so that the
orientation of the main unit can be changed.
4) Tighten the ball joint fixing screw.
z
Tighten the ball joint fixing screw with the allen
wrench (5.0 mm (3/16") across flats) supplied
with the projector to prevent the main unit
moving during the mounting work.
Attention
z
When loosening the ball joint fixing screw with the
pole being held by hand, take care to avoid the
hand(s) or fingers being pinched between the pole
and the main unit.
