Panasonic PT-JX200FBE, Installation Instructions Manual

Page: 17 / 30

ENGLISH - 17
Installation (continued)
„ „
When the hanging bolt installation location is a wooden beam
Spring washer
Hexagonal nuts
Hexagonal nuts
Hanging bolt
Hexagonal nut
Hexagonal nut
Hanging bolt
Flat washer
Spring washer
Flat washer
Spring washer
Attachment plate
Ceiling board
Beam
Flat washer
Spring washer
Flat washer
Protrudes 20 mm (25/32") to 30 mm (1-3/16")*
1
from the
ceiling surface.
*1 27 mm (1-1/16") to 30 mm (1-3/16") for double nuts
1) Drill mounting holes in reference to “Mounting hole dimensions” (

page 12).
z
Drill two through holes in the ceiling beam for the hanging bolts.
z
Drill two through holes in the ceiling board for the hanging bolts (M10).
2) Attach the two hanging bolts.
z
Securely fix the two hanging bolts to the ceiling beam.
z
If the place for fixing the hanging bolts is not strong enough, do give consideration to the safety factor and
provide sufficient reinforcement.
3) Attach the attachment plate to the hanging bolts.
z
The ends of hanging bolts at the attachment plate side should protrude by approx. 5 mm (3/16") from the
hexagonal nuts.
z
Make sure the distance from the surface of the attachment plate to the end of the hanging bolts is within 30
mm (1-3/16"). If the distance is too long, the projector mount bracket will not be able to be attached.
z
Be sure to use commercially available flat washers and spring washers to install the attachment plate.
Attention
z
Tighten the hexagonal nuts fixing the ceiling board and attachment plate together while considering the strength
of the ceiling board material. If the ceiling board material is of low strength, the ceiling board may be damaged
if the nuts are tightened to the specified torque. In this case, also take measures such as applying double nuts
or screw lock to prevent loosening of the hexagonal nuts.
Note
z
When mounting the attachment plate to the hanging bolts, there is no need to install the falling prevention wire
to the ceiling.