76
Available commands are listed below.
N Show the next page.
Press "N." The screen shows the next port.
P
Show the previous page.
Press "P." The screen shows the previous port.
A Enable/disable a port.
Press "A." The command prompt changes to "Select port number to be changed>."
Enter a port number you wish to change. Press "0" to change the settings of all
ports at a time. Then, the command prompt changes to "Enable or Disable port #
(E/D)>." Press "E" to enable the port. Press "D" to disable it. When you complete the
setting change, the display on the screen is automatically updated.
M Configure the speed and full-duplex/half-duplex settings for each port.
Press "M." The command prompt changes to "Enter port number>." Enter a port
number you wish to change. Press "0" to change the settings of all ports at a time.
Then, the command prompt changes to "Enter mode for port # (A/N)>." Press "A"
to enable the auto negotiation mode. Press "N" to disable it. If "N" is selected, the
command prompt changes to "Enter speed for port #(10/100)>." Select a desired
communication speed. Upon setting, the command prompt changes to "Enter
duplex for port #(F/H)>." Select "F" for full-duplex. Select "H" for half-duplex. When
you complete the setting change, the display on the screen is automatically
updated.
Mode:
A:
Enable the auto negotiation mode.
N:
Disable the auto negotiation mode (fixing the speed at Giga is
not supported).
Speed:
10:
Set at 10 Mbps.
100:
Set at 100 Mbps.
Duplex:
F:
Set at full-duplex.
H:
Set at half-duplex.
F
Enable/disable the flow control.
Press "F." The command prompt changes to "Select port number to be changed>."
Enter a port number you wish to change. Press "0" to change the settings of all
ports at a time. Then, the command prompt changes to "Enable or Disable flow
control for port # (E/D)>." Press "E" to enable the function. Press "D" to disable it.
When you complete the setting change, the display on the screen is automatically
updated.
S
Enable/disable the AUTO-MDI function.
