Panasonic PANAFAX DF-1100, Service Manual

Page: 174 / 333

Panasonic DF–1100
5–8
Function Parameter Table
No. Function Selections Parameter (see Note3)
1 = 1 m
Selects the maximum length of a document that can be
82 JAM LENGTH 2 = 2 m
Selects the maximum length of a document that can be
scanned
82 JAM LENGTH
3 = Unlimited
scanned.
83 SCAN SIZE
1 = A4
FAX Mode : 1. Flatbed transmission, sets the Original
size. (Length and Width)
2. ADF transmission, sets the Original
width. (The actual document length is
83 SCAN SIZE
2 = LTR
width. (The actual document length is
detected by the Read Point Sensor)
COPY Mode : Sets the Home position for the
ORIGINAL key.
84 LINE AS NO PAPER
1 = Ring (ring)
Selects whether to ring or send a busy tone to the
remote station when recording paper runs out or the
84 LINE AS NO PAPER
2 = Busy (keep line busy)
g y
remote station when recording paper runs out or the
unit cannot receive because of any trouble.
85 Not used
86 Not used
87 DARKEST LEVEL 0 = Lightest Contrast
Selects the contrast level.
88 NORMAL LEVEL
ƞ
Selects the contrast level.
0
´
1
´
2
´
3
´
4
´
5
´
6
´
7
´
8
´
9
´
10
Li h D k
89 LIGHTEST LEVEL 10 = Darkest Contrast
0 1 2 3 4 5 6 7 8 9 10
Lightest
² ³
Darkest
90 Not used
91 Not used
92 SMOOTHING
1 = Off
Selects whether the smoothing function is available 92 SMOOTHING
2 = On
Selects whether the smoothing function is available.
93 POWER SAVE TIMER 1 to 255 minutes in 1 minute step
Selects the idle period before the fusing heater is turned
93 POWER SAVE TIMER 1 to 255 minutes in 1 minute step
Selects the idle eriod before the fusing heater is turned
off after the last printing.
94
ƞ
99
Not used
Note 1: No. 70 LINE ERROR – Transmit condition of RTP/PIP or RTN/PIN
Setting
Signal
1 : 128 2 : 256 3 : 512 4 : 1024 5 : 2048 6 : Off
MCF/PIP
0-31 0-63 0-127 0-255 0-511 Always
RTP/PIP
32-63 64-127 128-255 256-511 512-1023 -
RTN/PIN
64-127 128-255 256-511 512-1023 1024-2047 -
Note 2: No. 71 TOTAL ERROR – Transmit condition of RTP/PIP or RTN/PIN
Setting
Signal
1 : 5% 2 : 10% 3 : 15% 4 : 20%
MCF/PIP
0-2 0-4 0-7 0-9
RTP/PIP
3-4 5-9 8-14 10-19
RTN/PIN
5- 10- 15- 20-
Note 3: The default setting of parameters depends on the country’s specifications or regulations. Print the
Function Parameter List to confirm the default settings.