Panasonic PANAFAX DF-1100, Service Manual

Page: 158 / 333

Panasonic DF–1100
4–46
Information Codes
Code Cause Description of Problem Phase Mode
572 XMT C
There was no response while machine
transmitted the data during remote diagnostic
communication.
Remote unit is defective.
573 RCV C
Unit could not receive the data from remote unit
during remote diagnostic communication.
Remote unit is defective.
580 XMT B
Sub – address transmission to a unit that has
their DIS bit 49 (NSF bit 155) OFF. Sub – address transmission to a unit that has
no Sub–address function.
581 XMT B
Sub – address Password transmission to a unit
that has their DIS bit 50 (NSF bit 156) OFF. Sub – address transmission to a unit that has
no Sub–address function.
601 XMT
ADF Door was opened during ADF
transmission.
602 XMT
Platen Cover was opened during ADF
Transmission.
623 XMT A
No document was in the ADF. (Built–in dialer
engaged)
Operator removed the document from the ADF
after dialing was completed.
Document is not set properly in the ADF.
630
XMT or
RCV
(Polling)
B
Redial count over.
No dial tone detected.
Sensor dial tone is not detected. (country
dependent)
Busy tone is detected. (country dependent)
T1 timer (35
ࠡ
5 sec) elapsed without a signal
from the receiver.
631 XMT A
”STOP” button was pressed during Auto
Dialing.
634 XMT
Redial count over with no response.
Note: Canadian models will not redial when
the communication fails due to no
response from the called station.
638 XMT
Power turned off with applicable data in
memory or during communication. Power switched off.
Power failure occurred.
870
Mem.XMT
Multi–copy
Memory overflow.
File register full.
879 Mem.RCV
Memory overflow during memory reception or
substitute reception.
962 Memory file access error. FCB PCB is defective.
975 Initial test Memory parity error.
Memory card was installed or removed when
data was in the DRAM on the FCB PCB or a
power failure has occurred while data was
stored in the memory.
995
Conf.XMT
Conf.Polling
Relay
Request
Parameter setting for Relay Comm. or Conf.
Comm. is invalid.