Before using
29
LSQT0975
ª
Selecting the remote control mode
If 2 Camcorders are used simultaneously, set the
mode for one pair of Camcorder and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1
Setting on the Camcorder:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
2
Setting on the remote control:
[VCR1]:
Press [
D
] and [
∫
] simultaneously.
1
[VCR2]:
Press [
E
] and [
∫
] simultaneously.
2
ª
Concerning the button-type battery
≥
When the button-type battery runs down,
replace it with a new battery (part number:
CR2025). The battery is normally expected to
last about 1 year, but it depends on operation
frequency.
≥
Keep the button-type battery out of the reach of
children.
≥
If the remote control mode of the Camcorder
and that of the remote control do not match with
each other, “REMOTE” will appear. When the
remote control is operated for the first time after
the Camcorder is turned on, “CHECK REMOTE
MODE” (
-73-
) will appear and operation is
impossible. Set the same remote control mode.
≥
The remote control is intended for indoor
operation. Outdoors or under strong light, the
Camcorder may not operate properly even
within the usable ranges.
Magic Wire Remote Control
This controller can be used from different high
and low angles. It is also handy when a tripod is
used. When you do not use the controller, attach
the clip to the grip belt. Left-handed users can use
this Camcorder more easily.
(1)
Recording start/stop button [REC]
(2)
Zoom lever [W/T]
(3)
Photoshot button [PHOTO SHOT]
ª
Connect the Magic Wire Remote
Control to the Camcorder
1
Plug the Magic Wire Remote Control into
the [REMOTE/MIC] terminal as far as it
goes.
ª
About the clip (on the backside)
When you move with the clip attached to your
pocket or elsewhere, beware of knocking over the
tripod and causing the Camcorder to fall off the
table.
≥
The [PHOTO SHOT] button on the Magic Wire
Remote Control cannot be pressed halfway.
≥
If the pin plug of the control is not inserted
securely into the [REMOTE/MIC] terminal as far
as it will go, normal operation may not be
ensured.
≥
Before using, make sure that the plug is
inserted securely into the terminal as far as it
will go.
2
1
(1)
(2)
(3)
REMOTE/MIC
LSQT0975_ENG.book 29 ページ ２００５年１２月１９日 月曜日 午前９時５１分
