6.12. Convection motor and
convection heater
1. Remove 1 screw holding side cover on cavity back plate.
2. Remove 1 screw holding side cover on the side of back
cover, then remove side cover & circuit breaker.
3. Disconnect 2 lead wires from convection heater terminals.
4. Remove 1 screw holding back cover on the lower of back
plate, then remove back cover and back cover C module.
5. Release 3 metal tabs which are holding the insulated wire
harness to the convection outside cover B.
6. Disconnect 2 lead wires from thermal cutout and convection
motor terminals respectively.
7. Remove 4 screws holding convection outside cover B on
cavity back plate.
8. Remove 4 screws shown below from the face of convection
outside cover B.
21
NN-CS599S
Summary of Contents for NN-CS599S
