Panasonic NN-CS599S, Service Manual

Page: 18 / 42

6.8. IR sensor
1. Disconnect connector CN8 from D.P.C. board HU.
2. Remove 1 screw holding IR sensor (U) on right heater
panel.
To replace swing motor of IR sensor
1. Release the locking lever of connector on swing motor,
then remove drive line.
2. Remove 2 screws holding swing motor on motor
mounting plate.
3. Remove swing motor from IR sensor assy.
6.9. Stirrer motor
1. Remove the motor cover by breaking off at the 8 spots
indicated by arrows with a cutter or the like.
NOTE:
After removing the motor cover, be sure that cut
portions are properly trimmed or bent to the inside
so that no sharp edges will be exposed to outside.
2. Disconnect 2 lead wires from stirrer motor terminals.
3. Remove 2 screws holding stirrer motor.
NOTE:
After reinstalling the new stirrer motor and
reconnecting the 2 lead wires, reinstall the motor
cover by rotating it around 180, tucking the 2 tabs
under the base in the 2 provided slots, then screw
the single tab to the base using a screw.
18
NN-CS599S