Panasonic NC-HKT081, Operating Instructions Manual

Page: 6 / 16

English
EN10 EN11
How to Use
1
Open the lid and fill with
water.
2
Close the lid, put the
machine on the power base
and insert the power plug.
Adjusting the length of the power cord
* Wind the power
cord on the
bottom of the
power base
to adjust the
length.
3
Make sure that the hotwater
supply port lock lever is on
the “ ” side, then turn on
the power switch. (Press “ ”)
4
Remove from the power
base. Put the hot-water
supply port lock lever is
on the “ ” and pour.
Boil dry protection
When the power switch is on with dry or empty vessel, overheat will activate the dry boil
protector to cut off the power to prevent accidents and malfunction.
① Cool down the body sufficiently.
② Remove the body from the power base and fill the water.
③ Place it on the power base and turn on the power switch again.
* If you boil the machine without water, it may smell strange.
* Pass the power
cord out through
the the position of
opening
* Do not put the
power base on the
power cord.
①
②
Pour in water
with another
container!
Opening the lid
• Pinch the
open lid
button and lift
the lid.
* Do not pour
water over
the full
water level .
MAX 0.8L
①
②
③
Closing the lid
• Push firmly
from above
until the claws
on both sides
snap and you
hear a click.
Note
• Do not insert the power plug when filling
the water and before closing the lid.
During use, the power
indicator lights up.
When the water has boiled, the power
switch turns off automatically.
(
The machine takes around 4 minutes and 30
seconds to boil. Under the following condition:
Water temperature 23 °C, room temperature
23 °C, water to max level, 220 V.
• To stop boiling before the
water has boiled, turn off
the power switch.
Note
• Immediately after the water has boiled, do
not force the machine to continue heating
the water by keep pressing the power
switch. (It may cause malfunction.)
• When the power switch is turned off
automatically, the switch can not be opened
again within about 3 minutes. (Because the
hot water temperature is too high.)
)
Start boiling the
water.
(
Power indicator
lights up.
)
■
After use, pour out any remaining
water.
Push up
Red indication