English
EN12
EN13
How to Clean
Please check the following points before arranging for service.
Problem
Cause
and Action
Power switch does not
turn on.
●
Is the power plug
plugged in?
●
Insert the power plug into
the outlet. (P. EN10)
●
Is the body set correctly
on the power base?
●
Ensure the body is set
correctly.
●
Is there a piece of metal
or foreign material
adhered to the power
base connector or body
connector?
●
Remove the piece of
metal or foreign material.
(P. EN12–13)
●
Once the machine has boiled, the power switch is
automatically turned off and cannot be turned on for
approximately 3 minutes.
Water does not boil.
●
Did you try to turn on
the power switch without
water in the machine?
(
The Boil dry protection
will work to turn off the
power switch.
)
●
Fill with water and turn
on the power switch.
(P. EN10-11)
●
Is the power switch
turned off?
●
Press to “ ”, and turn on
the power switch. (P. EN11)
Troubleshooting
■
Clean the appliance after every use.
■
Before cleaning, be sure to disconnect the power plug from outlet, pour away the hot
water, and cool down the body.
Note
• Do not use detergent. (This may cause a residual odour.)
• Do not use benzine, thinner, alcohol, bleach, polishing powder, metal brush or nylon
brush, otherwise the surface will be damaged.
• Do not wash in a dishwasher.
• Do not clean the appliance with pointed object such as a toothpick or pin.
Body connector
Body
(Outside)
Wipe with a well-wrung cloth.
(Inside)
Rub with a soft sponge and rinse.
Limescale build-up
Minerals such as calcium carbonate contained in the water build up in the machine.
Please remove the limescale.
①
Remove it regularly using:
• limescale remover
Follow the instructions supplied with the limescale remover.
• citric acid
Fill the machine with water half way up and boiled it. After switch is off, put
approx. 20
g
of citric acid and stir it well. Let it still for approx. 30 min.
②
After removal, repeat the following steps a few times: fill with water, boil, pour away.
Lid
Wipe with a well-wrung cloth.
Power base
Wipe with a well-wrung cloth.
Power base
connector
To store
• Dry it thoroughly.
• Put in a plastic bag and seal the bag to prevent insects etc. from entering.
Summary of Contents for NC-HKT081
Page 16: ...Memo Memo ...