GB14
GB15
English
Disassembly and assembly of the blender jug base
Disassembly and assembly of the lid unit
Assembly of the ice pack and drip tray
Before Use - Disassembly and Assembly -
<Disassembly>
Attach the jug base holder while aligning the
▲
marks on the blender jug base and jug base
holder. Then turn it anticlockwise firmly.
1
Pull out the jug base holder.
•
Do not press tabs on the jug base holder
to avoid the blender jug base falling.
2
Tab
(Both side)
Press tabs on the jug base holder to release
the blender jug base from it.
3
Tab
(Both side)
1
Attach the jug gasket into the
groove on the bottom of the
blender jug.
(Failure to install the jug gasket
completely into the groove may
lead to leaking liquids.)
2
Attach the jug base holder while aligning the
▲
mark on the blender jug base and jug base
holder, then press the jug base holder until you
hear a click sound.
3
Insert the blender jug base into the blender jug
after aligning, then turn the jug base holder
clockwise until it stops turning. ( The
“
O
”
mark
on the blender jug base will align with the line
on the blender jug.)
<Assembly>
4
Press tabs to remove the jug base holder.
Tab
(Both side)
<Ice pack>
Use the ice pack tape strips to secure the ice pack over and
under the blender jug handle with the label facing the outer side of the pack.
<Drip tray>
Set the drip tray onto the motor housing and push it down completely.
When removing the drip tray after blending, beware of water spillage.
●
Pay attention when handling the blender jug base. Blades are sharp.
●
If the gasket is not attached to blender jug and/or the blender jug base is not attached firmly onto the
blender jug, liquid may leak out.
Note
Note
1
Pull up the tab to open the lid.
<Disassembly>
2
Turn the cap anticlockwise and pull up to
remove it.
●
When you force open the lid unit, be careful not
to let any liquid splash. Additionally, take
caution with the emerging steam, especially
when blending hot liquids.
Note
1
2
Attach the lid gasket properly onto the lid
groove, align the lid with the
▼
mark on the
cap. Then turn the cap clockwise until the
▼
mark on the lid aligns well with the
portion
on the cap and you hear a click sound. (If the
lid gasket is not properly installed, liquid may
leak through the lid.)
Place the lid unit on the blender jug and press
down.
<Assembly>
●
When the tamper is not in use, make sure to attach
the cap while blending.
●
When using the “Frozen” menu selection, insert the tamper
from the lid opening instead of attaching the cap.
Correct
Incorrect
●
Make sure the lid unit is attached firmly.
Note
