GB24
GB25
English
Troubleshooting
Replacement Parts
Part name
Part number
Jug gasket
VE28B2461
Lid gasket
VE22B2461K0
Ice pack
VU03E246
Circuit Breaker Protection
In case of overload, the circuit breaker will be triggered, and the blender
will automatically stop running. You can take the following steps to
disable the protection.
1. Remove the blender jug from the motor housing, and reduce the
ingredients to less than the half capacity.
2. Turn the motor housing over, and press the reset button on its bottom.
3. Replace the blender jug, and after auto menu or manual mode setting,
press “
” to blend again.
Specifications
MX-ZX1800
Power supply
230 - 240 V 50 Hz
Power consumption
1200 - 1300 W
Speed control
10 speed control
Operation rating
Continuous operation
(Repeat the cycle of 9 min ON and then 10 min OFF)
Working capacity
1800 mL
Dimensions (W × D × H) (approx.)
22.8 × 24.0 × 44.7 cm
Mass (approx.)
6.1 k
g
Length of the mains lead (approx.)
1.9 m
Airborne Acoustical Noise
91 (dB (A) ref 1 pW)
Circuit breaker
(on the bottom)
Reset
■
Please check following points before arranging for service.
Problem
Cause and Action
Mixture in the
blender jug is
leaking.
●
The blender jug base is attached loosely.
→
Tight the blender jug base up firmly onto the blender jug. (P. GB14)
●
The gasket of the lid or blender jug is not attached correctly.
→
Attach the gasket correctly. (P. GB14)
●
The gasket of the lid or blender jug is damaged.
→
Replace the gasket. (P. GB25)
▶
There is abnormal
noise or vibration.
●
Too much ingredients in the blender jug.
→
Stop the appliance and reduce the ingredients.
●
The blender jug base is attached loosely.
→
Tight the blender jug base up firmly onto the blender jug. (P. GB14)
▶
The blade is spinning.
●
Too much Ice cubs or frozen fruit.
→
Turn off the appliance and after the blade is completely stopped,
insert the tamper to circulate. (P. GB19)
●
Quantity of the liquid is low.
→
Add liquid.
▶
The texture and
consistency of the mixture
did not turn out well.
▶
●
When you are blending quantity of less or over 4 servings, texture and
consistency may not turn well on auto menus.
→
Try using the manual mode. (P. GB20-21)
The appliance stops
during blending and
and are flashing
alternately.
▶
●
The overloading protection is activated.
・
Too many ingredients
・
Using hard ingredients
・
Selected speed is too low for ingredients
→
Turn off the appliance and wait 10 minutes before next use.
*
There is a possibility of failure if it is re-used immediately.
When re-using the appliance, allow the blade to rotate freely by
reducing the amount of ingredients or by increasing the speed.
The and
indicators are
flashing alternately.
The and
indicators are
flashing alternately.
▶
●
This is a malfunction.
→
Contact an authorized Panasonic service center for check and repair.
The appliance stops
during blending, and
the
and
indicators are
flashing alternately.
▶
●
This indicates that the motor temperature is overheating. Please stop
using the appliance and wait until the temperature goes down. (When the
appliance enters standby mode as in GB18 Figure 1, the temperature
has gone back to normal.)
Replacement parts are available at your dealer or Service Center.
