1. Install the exhaust tank.
1) Take out the exhaust tank from the product and remove the
packings.
2) Pour water up to the LOW (minimum) level mark, insert the packings
to the holes of the product and connect the exhaust hoses.
3) Make sure that the exhaust hose packings have been
inserted completely in the holes of the exhaust tank.
4) Stow the exhaust tank inside the product.
Make sure that the exhaust hoses are not bent or twisted. If they
are so, air in the chamber is hard to escape and an error message
may appear.
The water in the exhaust tank increases in each sterilizing operation.
If it will increase up to the HIGH (maximum) level mark, once discard
the water and fill the tank with fresh water up to the LOW level mark.
Do not pull out the exhaust tank by force from the product with the
exhaust hose being connected. Otherwise, trouble may be caused.
Insert the packings up to the hilt while turning them clockwise and
counterclockwise. If they are turned in only one direction, the exhaust
hoses will be twisted to cause trouble.
Memo
Advisory note
Advisory note
Packing
Exhaust hoses
Hole
Hose in tank
HIGH level mark
LOW level mark
Exhaust tank
How to Use
16
(Continued)
ɿ
Be careful about the position of the exhaust hose
insertion holes.
Be sure to insert the hose in the tank into the holes at
the back inside the exhaust tank.
Failure to observe this caution may cause large steam leaks
from the tank on the rear side.
Be sure to use the exhaust tank attached to the product.
If the packings of the exhaust hose have not been inserted
sufficiently, steam may escape and result in burns.
ɿ
When using the exhaust tank attached to the product,insert
the exhaust hose packings securely in the holes of the
exhaust tank.
CAUTION