Panasonic KX-UDT121, Operating Instructions Manual

Page: 60 / 68

Problem Possible Cause Solution
I cannot connect a
Bluetooth headset to
the handset. The Bluetooth headset or the
Bluetooth function of the handset
is off. •
Confirm that the Bluetooth
headset is turned on.
•
Confirm that the Bluetooth setting
of the handset is turned on. For
details, see "Turning Bluetooth
On or Off (Page 31)".
A connection or registration error
has occurred. •
If the Bluetooth headset is
already registered to another
Bluetooth device such as a cell
phone, disconnect the Bluetooth
headset from the cell phone, and
then perform the connection
procedure from the handset.
•
The Bluetooth headset is not
registered to the handset.
Register the Bluetooth headset.
For details, see "Registering a
Bluetooth Headset (Page 32)".
Some headset
features are not
functioning. The handset does not support
enhanced features such as last
number redial or call reject.
—
An error tone is heard
when I try to connect a
Bluetooth device to
the handset. The Bluetooth function is not
ready. •
The Bluetooth function cannot be
accessed immediately after
turning on the handset. Wait a
few seconds and try again.
•
A connection could not be made
between the handset and the
Bluetooth device. Wait a few
seconds and try again.
I cannot remember the
PIN number.
—
Consult your administrator or dealer.
The "
Delete All
"
operation to delete all
phonebook entries is
not functioning.
The battery is drained, which
prevents the operation from being
completed. Charge the battery fully, then try
again. For details, see "Charging the
Battery (Page 54)".
The System Speed
Dial Download of the
KX-NS1000 PBX is
enabled but some of
the phone numbers to
be downloaded
(default: 100) are not
downloaded to the
handset phonebook.
*1
The total number of the phone
numbers registered to the handset
and the phone numbers
downloaded from the PBX exceeds
the handset phonebook capacity
(500 numbers). Delete the phone numbers of the
handset phonebook which were
registered manually.
*1
This item is applied only when the CS is connected to a KX-NS1000 PBX.
60 Operating Instructions Document Version 2013-03
Appendix