Installation
Installation Manual
69
2.7
Starting the System for the First Time
2.7.1
Starting the System for the First Time
CAUTION
•
Before touching the system clear switch and the reset button, put on a grounding strap.
Please refer to 2.2.4
Frame Ground Connection.
•
Once you start up the system and if you unplug the system, do not perform the following
procedures to start the system again. Otherwise, your programmed data is cleared. To start
the system, just plug in the system.
•
The system will continue to be powered even if the power switch is turned "OFF".
•
The power supply cord is used as the main disconnect device. Make sure that the outlet is
located/installed near the equipment and is easily accessible.
1.
Set the system clear switch to the "CLEAR" position.
2.
Plug the AC power cord into the system and an AC outlet, and turn on the unit.
3.
Press the reset button. (The power indicator will flash.)
4.
While the power indicator starts flashing (within about 10 seconds), return the system clear
switch to the "NORMAL" position. If successfully executed, the DPTs should show the
System Clear Switch
Reset Button
CLEAR
NORMAL
To AC Outlet
