Chapter 6
Useful Information
77
Problem
While programming or searching, the
unit starts to ring and stops the
program/search.
The unit does not display the caller’s
phone numbers.
The display goes to the stand-by mode
while viewing the Caller List or
phonebook.
does not function.
The paged handset does not answer.
While using the intercom, two tones
sound.
The unit misdials when connected to a
PBX.
You cannot register the handset in the
base unit.
Remedy
•
To answer the call, press
. Start again from
the beginning after hanging up.
•
Other telephone equipment may be interfering with
your telephone. Disconnect it. Try again.
•
Other electrical appliances connected to the same
outlet may be interfering with the Caller ID
information. Telephone line noise may be affecting
the Caller ID information.
•
Do not pause for over 60 seconds while searching.
•
The handset is too far from the base unit.
•
The handset is engaged in an outside call or is
viewing the Caller List or phonebook. Wait until the in
use indicator (
) light goes out.
•
The handset is not in the same radio area.
•
The handset is engaged in an outside call.
•
The handset has been cancelled or has not been
registered. Register the handset in the base unit
(p. 64).
•
A call is being received. To answer, press
twice.
•
Check the pause function (p. 39).
•
The base unit has registered a maximum of
6 handsets or the handset has registered a maximum
of 4 base units.
•
There is interference from other electrical units.
Locate the handset and base unit away from them.
•
You must finish registration within 1 minute after the
ringer tone sounds, or programming will be cancelled
(p. 64).
KX-TCD965EC-6(74~84) 99.9.27 7:59 PM Page 77
