Panasonic KX-NS300, Installation Manual

Page: 168 / 300

b.
Select Obtain DNS server address automatically .
c.
Select Obtain DSP IP address automatically .
Notice
The boxes will turn grey and the IP address information will be assigned automatically.
Write down the address information assigned to the PBX for future reference.
When not using a DHCP server:
a.
Select Use the following IP address .
b.
Enter an IP address
*1
, Subnet Mask
*2
, and Default Gateway
*1
.
(The default gateway may not need to be specified depending on your network configuration.)
c.
Select Use the following DNS server address .
d.
Enter the preferred and alternative DNS IP addresses
*1
.
e.
Select Use the following DSP IP address .
f.
Enter IP address
*1
for installed DSP card.
4.
Click OK .
a.
A screen will appear stating that any changes made in step 3 will be activated after the PBX is restarted.
b.
Click OK .
5.
Restart the PBX.
a.
Click Maintenance
®
System Control
®
System Reset .
b.
On the System Reset screen, click Backup .
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
Notice
•
Do not change the IP address of the PBX once IP telephones are registered to the PBX using the set
IP address. The IP telephones will not operate properly if the IP address of the PBX is changed. When
an external DHCP server is used to automatically assign IP addresses, it must be configured to always
allocate the same IP address to the PBX. For details, consult your network administrator.
•
If an external DHCP server is in use, it must be able to use a "client identifier" option specified by RFC
2131.
•
If an external DHCP server is in use, the KX-NS300 DHCP Server feature must be disabled.
•
The PBX will not start properly if IP addresses cannot be assigned automatically by the DHCP server
when the PBX has been set to obtain IP addresses automatically. In this case, you need to consult
your network administrator because the DHCP server in your network may not be running or a network
failure may have occurred. If the DHCP server is not available, enter IP addresses manually, then
restart the PBX.
•
During a long programming session, it is highly recommended that you periodically save the system
data to the PBX memory. If the PBX undergoes a sudden power failure or if the system is reset for
some reason, all the system data in RAM will be lost. However, if system data has been saved to the
PBX memory, it can be easily reloaded.
To save the system data to the PBX memory while programming, click the disk button (
)
®
Yes
®
OK . Be sure to save the system data to the PBX memory before restarting the PBX, or any changes
may be lost.
•
When no operations are performed for more than 60 minutes (default), you will be automatically logged
out from Web Maintenance Console and unsaved data will be lost.
Changing the Display Language
The language used for Web Maintenance Console can be changed after the Easy Setup Wizard has completed.
1.
Click Setup
®
Users
®
User Profiles .
2.
Select the check box for the Installer level account.
168 Installation Manual
5.4.1 Easy Setup Wizard