4.
Temporarily install the IP-CS at least 2 m above the floor, and place the antennas so that they are pointing
in directions that are 90 degrees apart (for antenna diversity), as follows:
45º
45º
90º
Notice
Be sure to install the Master CS at the center of the installation site.
Step 3 - Setting a PS for the Site Survey
Assign the CS ID number to the PS.
Press 1, 9, and POWER
for more than 2 seconds.
0 to 9 and A to F
CS ID No.
1
9
9
2
ABC
To enter letters
A:
To the initial display
3
DEF
4
GHI
0
0
1
5
JKL
2
ABC
+
+
+
+
+
+
C:
E:
B:
D:
F:
Step 4 - Site Survey
1.
Enter Radio Signal Test mode.
Press 1, 9, and POWER
for more than 2 seconds.
1
9
9
0
RADIO STRENGTH
<<< MEASURING >>>
RADIO STRENGTH
CH0 SLOT:06 SYNC
L:12
0000/0100
CS-ID:9005301234
Display example:
Error Rate (%)
= Frame error/Frame counter × 100
Radio Signal Strength Level
Note
When the error rate is 3% or more, measure the error rate at the same location at least 5 times. You
must disconnect the CS and then reconnect it to take each measurement. If the error rate is consistently
Document Version 2009-12
Quick Installation Guide
67
A Step-by-step Instructions for Easy Installation
