32
“
Setting Up the Parameters
Instructions for the data fields
Unless the ISP requires you to enter the parameters, leave these data
fields blank.
When the ISP uses the DHCP server function, basically no
settings of the parameters are needed except for the entry of the
Device Name. Select the DHCP radio button according to the
check mark in the
✎
Memo
1
(See p. 21, 25 or Quick Prep
Sheet). Or, check the information provided from the ISP and
enter the ISP specified Device Name in the data field if required.
If not required, leave the data field blank.
When the ISP requires you to use the PPPoE connection, entry
of these data fields is needed.
Enter ISP specified User Name and Password. Connection to the
ISP is made using this User Name and Password.
Enter ISP specified Service Name if required. When a Service
Name is not specified by the ISP, leave this data field blank.
Enter ISP specified Access Concentrator Name (sometimes
specified as “AC Name”) if required. When the name is not
specified by the ISP, leave this data field blank.
When the ISP requires you to use the static IP connection, enter
the ISP specified IP Address and Netmask (Subnet mask) in
each data field. Set the parameters recorded in the
✎
Memo
2
and
✎
Memo
3
(See p. 21, 25 or Quick Prep Sheet).
Internet Connection
Depending on the ISP, your Internet connection will be one of several types. Check the
information provided by the ISP and make sure which type of connection is required. Then,
select the appropriate connection type from DHCP, PPPoE or Static on the KX-HGW200 web
screen and enter the parameters if required by the ISP.
Default Gateway
DNS
DHCP
≥
Device Name
PPPoE*
≥
User Name/
Password
≥
Service Name
≥
Access
Concentrator Name
Static
≥
IP Address
≥
Netmask
≥
Gateway
≥
DNS Server 1/
DNS Server 2
≥
Domain Name
When the ISP requires them, enter the domain name server IP
Addresses in these data fields. When the DNS server 2 data field
is not specified, leave this data field blank.
When the ISP requires it, enter the domain name in this data field.
Set the parameters recorded in the
✎
Memo
5
(See p. 23, 25 or
Quick Prep Sheet).
When the ISP requires it, enter the gateway IP Address in this
data field. Set the parameter recorded in the
✎
Memo
4
(See
p. 22, 25 or Quick Prep Sheet).
*The parameters for the PPPoE connection have not been collected in the
✎
Memo
sections of the previous pages or Quick Prep Sheet. To set these parameters to the
KX-HGW200, refer to the information from your carrier or ISP.
PQQX12817ZA
P30-45
01.3.8
3:20
PM
y [ W 32