Priority
Setting Method
1
1-1
Provisioning with the standard configuration file
1-2
Provisioning with the product configuration file
1-3
Provisioning with the master configuration file
Settings configured from the Web user interface or the phone user interface
According to the table, settings configured later override previous settings (i.e., settings listed lower in the table
have a higher priority).
Notice
•
Make sure to perform Reset to Factory Default before connecting the unit to a different phone system.
Contact your phone system dealer/service provider for further information.
2.4 Configuration File Specifications
The specifications of the configuration files are as follows:
File Format
The configuration file is in plain text format.
Lines in Configuration Files
A configuration file consists of a sequence of lines, with the following conditions:
•
Each line must end with "<CR><LF>".
Note
<CR> or <LF> alone may be acceptable under certain conditions.
•
Lines that begin with "
#
" are considered comments.
•
Configuration files must start with a comment line containing the following designated character sequence
(44 bytes):
# Panasonic SIP Phone Standard Format File #
The hexadecimal notation of this sequence is:
23 20 50 61 6E 61 73 6F 6E 69 63 20 53 49 50 20
50 68 6F 6E 65 20 53 74 61 6E 64 61 72 64 20 46
6F 72 6D 61 74 20 46 69 6C 65 20 23
•
To prevent the designated character sequence being altered by chance, it is recommended that the
configuration file starts with the comment line shown below:
# Panasonic SIP Phone Standard Format File # DO NOT CHANGE THIS LINE!
•
Configuration files must end with an empty line.
•
Each parameter line is written in the form of XXX="yyy" (XXX: parameter name, yyy: parameter value).
The value must be enclosed by double quotation marks.
•
A parameter line written over multiple lines is not allowed. It will cause an error on the configuration file,
resulting in invalid provisioning.
Configuration Parameters
•
This unit supports one telephone line. However, for some parameters, the line number must be specified.
For example, "
VM_NUMBER_1
" is a parameter to a set voice mail server for telephone line 1.
•
Some parameter values can be specified as "empty" to set the parameter values to empty.
Example:
Document Version 2015-02
Administrator Guide
49
2.4 Configuration File Specifications
