Panasonic HDC-SD100, Operating Instructions Manual

Page: 111 / 140

111
VQT1T90
Setup
2
Connection and recognition
After the software applications are installed, this unit must be connected to the PC and be correctly
recognised by the PC.
Remove the supplied CD-ROM from your PC.
USB cable (supplied)
1
Connect this unit to the AC
adaptor.
2
Turn on the unit.
This function is available in all modes.
3
Connect this unit to a PC.
The USB function selection screen will appear.
Insert the USB connectors as far as they will go.
Do not use any other USB connection cables
except the supplied one. (Operation is not
guaranteed with any other USB cables.)
4
Select [PC CONNECT] and press
the cursor button.
This unit is automatically detected by the PC.
[AVCHD CONNECT] is for future expansion menu.
When the unit is connected to a PC, the
operation mode cannot be changed and its
power cannot be turned off.
Disconnect the USB cable, before turning
this unit off.
Do not disconnect the USB cable or the AC
adaptor while the card access lamp is on or
card access icon (
) appears on the unit
screen. Doing so may damage the data.
! If the driver has not been
recognised properly
Use the following methods to enable it to be
recognised.
Method 1:
Turn off the unit and your PC once and try
verifying again.
Method 2:
Remove the SD card and try verifying again.
Method 3:
Try connecting the unit to another USB port on
your PC.
! To disconnect USB cable safely
1 Double click the ( ) icon in task
tray displayed on the PC.
Depending on your PC’s settings, this icon
may not be displayed.
2 Select [USB Mass Storage Device] and
click [Stop].
3 Verify [MATSHITA HDC-SD100/SD USB
Device] is selected and click [OK].