MASSAGING HEADS RANGE MOVEMENT
<UPWARD, DOWNWARD MASSAGE>
Massage range width : 2 15/16 in. (75 mm) (width cannot be adjusted)
<TAPPING, ROLLING, REGIONAL ROLLING, TAPPING ROLLING AND REGIONAL
TAPPING ROLLING>
Massage range width : 3 5/16 in. or 4 5/16 in. (85 mm or 110 mm)
The width between the massage heads can be adjusted for tapping, rolling, regional rolling,
tapping rolling massage and regional tapping rolling massage.
The heads can be set at different widths for a wide range, giving you a massage any place
you like from the neck to the lower back.
Neck
2 15/16 in. (75 mm)
(Minimum width)
3 5/16 in. (85 mm)
4 5/16 in (110 mm).
23 1/16 in. (600 mm)
23 1/16 in. (600 mm)
Lower back
Neck
Lower back
18
TROUBLESHOOTING GUIDE
Before requesting service for this unit, check the table below for the possible cause of the
problem. Some simple checks or minor adjustment on your part may eliminate the
problem and restore proper operation. If you are in doubt about some of the check points,
or if the remedies indicated in the chart do not solve the problem, refer to the directory of
authorized servicenters (see the servicenter list included) to locate a convenient
servicenter, or consult your authorized Panasonic dealer for instructions.
Problem
Probable cause(s)
Suggested Remedy
Massage does not start.
The power cord is not plugged
in.
Plug the power cord into an AC
outlet (120 V).
The power source switch is at
the “off ” position.
Slide the power switch to “on”.
If the massage heads are
forcibly locked, they will stop for
safety.
Raise your back slightly and
push the start/reset button.
All lamps on controller flash and
massage heads Stop.
The massage heads must move
to the narrowest position for a
rolling massage.
Wait until the massage heads
reach the narrowest position.
Kneading massage cannot be
changed immediately to a rolling
massage.
Your shoulders are too high.
Shift your waist forward and
recline the chair back.
Massage heads do not reach
your shoulders.
This is because an alternating
tapping mechanism is used. It is
not a malfunction.
It seems like the massage heads
are at different heights.
Alternating tapping mechanism
When stopped, the misalignment
is approx. 1 cm at most.
Approx.
13/32 in. (1 cm)
at most
Approx.
13/32 in. (1 cm)
at most
19
EP790K230
説
18-19
