Precautions with regard to safety
E
NGLISH - 9
Important
Information
Do not reach for the openings beside the optical
lens, during horizontal or vertical movements of the
lens.
Failure to observe this may cause injury.
Replacement of the lamp unit should only be carried
out after it has completely cooled off.
Failure to observe this may cause burns.
We are constantly making efforts to preserve and maintain a clean environment. Please take non repairable
units back to your dealer or a recycling company.
Do not subject the projector to excessive vibration
or shocks.
The projector lens need to be handled with care.
Cover the lens with the lens cover when transporting
the projector.
When transporting the projector, hold the body at
the bottom securely.
Do not hold the adjuster legs or the top cover to move
the projector, as this may damage the projector.
Be sure to always remove the lens during transport.
The projection lens is susceptible to vibrations and
impacts.
Avoid setting up in places which are subject to
vibration or shocks.
The internal parts can be damaged, which may cause
malfunctions or accidents.
Avoid setting up in places which are subject to
sudden temperature changes, such as near an air
conditioner or lighting equipment.
The life of the lamp may be shortened or the projector
may be turned off. See “TEMP indicator” on page 28.
Do not set up the projector near high-voltage power
lines or near motors.
The projector may be subject to electromagnetic
interference.
If installing the projector to the ceiling, ask a
qualified technician to carry out all installation work.
You will need to purchase the separate installation kit
(Model No. ET-PKD56H, ET-PKD55S). Furthermore,
all installation work is should only be carried out by a
qualified technician.
If using this projector at high elevations 1 400 -
2 700 m (4 593 - 8 858 ft) sea level, set the HIGH
ALTITUDE MODE to ON.
Failure to observe this may result in malfunctions or
the life of the lamp or the other components may be
shortened.
Be sure to install the projection lens cover after
installing the projection lens.
If this not done, dust will collect inside the projector
and problems with the projector will result.
In order to get the best picture quality
Draw curtains or blinds over any windows and turn off
any lights near the screen to prevent outside light or
light from indoor lamps from shining onto the screen.
In rare cases, wafture can occur on the screen
affected by the warm air from the exhaust port
depending on the environment. Make sure that there
is no equipment in front of the set which will
recirculate the exhaust air from the set or other
nearby equipment.
Do not touch the surfaces of the lens or the front
glass with your bare hands.
If the surface of the lens becomes dirty from
fingerprints or anything else, this will be magnified
and projected onto the screen. Moreover, when not
using the projector, close the front panel cover.
Cautions when transporting
Cautions when installing
Cautions on use
