35
RQT6450
Reference
34
RQT6450
Reference
Solution
Check that the battery is inserted correctly.
9
Replace the battery if it is drained.
9
Aim the remote control at the remote control signal sensor.
9
This function is dependent on software availability.
Some DVDs require you to change the languages through menus.
This function is dependent on software availability.
Turn the subtitles on.
E
Subtitles may fail to appear around the A and B points in A-B repeat,
and around the points you marked to play again.
This function is dependent on software availability.
There may be parts of multi-angle DVDs where different angles are
not recorded.
Do the following to reset the unit to its original factory settings. While
the unit is stopped, press and hold [
;
], [
:
] (backward), and
[
1
, – ON] on the main unit for about 3 seconds until the
message “Initialized” disappears from the LCD, then turn the
unit off.
Separate the unit from mobile phones.
The speaker is off if the LCD is closed or headphones are connected.
Turn up the volume.
=
Check all connections and settings.
L
,
M
,
N
Check input mode of the other equipment.
ADVANCED SURROUND may cause distortion with some discs.
Turn ADVANCED SURROUND off if this occurs.
A
Problem
No operation with
remote control.
The audio soundtrack
or subtitle language
cannot be changed.
Subtitles not shown.
Angles cannot be
changed.
You have forgotten
your ratings password.
You want to reset the
unit to the factory
settings.
There is a lot of noise.
No sound from the
unit’s speaker.
No sound from other
speakers.
Distorted sound.
Before requesting service, make the below checks. If you are in doubt about some of the check points,
or if the remedies indicated in the chart do not solve the problem:
In the U.S.A., contact the Panasonic Customer Call Center at 1-800-211-7262, or
e-mail [email protected], or web site (http://www. panasonic.com).
In Canada, contact Panasonic Canada Inc. Customer Care Centre at 1-800-561-5505,
web site (www.panasonic.ca), or an authorized Servicentre close to you.
Reference pages are shown as black circled numbers
:
.
Troubleshooting Guide
Problem
No power.
Unit turns off
automatically.
Unit doesn’t work
when powered by
battery.
Cannot charge or the
[CHG] indicator fails to
light.
No response when
buttons are pressed.
Play fails to start or
stops soon after
starting.
Solution
Check connections to the AC adaptor or battery pack.
: ;
You cannot turn on the unit with the remote control if the unit is
powered by the battery pack.
The unit turns off after it has been stopped for about 15 minutes
(5 minutes when the unit is powered by the battery pack) to conserve
power. Turn the unit on again.
The unit and battery pack have protection circuitry that activate if they
become too hot or too cold. They will not work if this occurs. Use the
unit and battery pack between 5
o
C (41
o
F) and 35
o
C (95
o
F).
The battery pack can only be recharged when the unit is off.
The charging time increases if the battery pack is warm and charging
may not be possible under some circumstances. Wait for it to cool.
Check connection to the AC adaptor.
:
Some discs prohibit certain operations.
If there is no response at all, the unit may have been affected by
lightning or static electricity. Try turning the unit off and on again.
Alternatively, turn the unit off, disconnect the power source (AC or
battery pack) reconnect the power and turn the unit on again.
Condensation may have formed in the unit.
Wait 1 or 2 hours for it to clear.
This unit cannot play discs other than those specified.
8
Clean the disc.
9
Ensure the disc is inserted correctly.
=
Check that the DVD-RAM has something recorded on it.
