Panasonic DVCPRO AJ-CA901P, Service Manual

Page: 133 / 268

INS-3
1-3-2. Removal of Battery Holder
1. Remove 4 Screws (A).
Fig. 3-1
2. Disconnect Power Connectors P9807 and P1006
and then remove Battery holder.
Fig. 3-2
3. Unscrew 2 screws (B) and then remove a
connector cover.
Fig. 3-3
1-3-3. Cable Connections part 1
1. Loosen 4 screws and then remove Side panel
(Cassette slot side) on the Unit.
2. Wire harness from AJ-CA900H base plate should
be passed through rear panel as shown below.
Fig. 2-4
3. Connect Power connectors on Battery holder to
connector P9807 and P1006.
4. Fix “GND Cable” with Gold Screw (Included with
AJ-CA900H) to Camcorder as shown figure 3-5.
(GND Cable have to be fixed on the direction of the
lower right at 45 degrees.)
5. Connect Flat cable to connector P9806 on INT
CONNECT P.C.Board.
Fig. 3-5
Screws (A)
Power connectors
Screws (B)
Flat Cable
GND Cable
Power connectors