Panasonic DVCPRO AJ-CA901P, Service Manual

Page: 125 / 268

INF-11
5. INTERNAL SWITCH SETTING
The internal switch setting on each circuit board are shown below.
The switches which are for “Factory use only” must be set to the “factory default”.
BOARD Ref. No. SW
FACTORY
DEFAULT
FEATURE
SW1 - FRONT Control source select (FRONT / RCOP)
BS FRONT
SW3 1-8
ALL OFF Factory Use only
1 ON
Output signal select for Y/G, Pb/B, Pr/R connector
ON : Y, PB, PR OUT / OFF : G, B, R OUT
2 OFF
3
ON
4
ON
5 ON
Factory Use only
6 OFF
Color-bars type select
ON : SNG Color-bars / OFF : SMPTE or FULL Color-bars
7 ON Factory Use only
BS DIGITAL
SW2
8 ON Factory Use only
SW1 - 4W Incom type select (4W / RTS / 2W)
SW2 - ON ENG RTS LOAD (ON / OFF)
SW5 -
MAKE
R Tally type select (MAKE / POWER)
SW6 - MAKE G Tally type select (MAKE / POWER)
SW7 -
0dB
MIC 1 output level (0dB / -20dB)
SW8 - 0dB MIC 2 output level (0dB / -20dB)
BS AUDIO
SW9 - 0dB PGM 1 output level (0dB / -20dB)
SW1 1 ON
Adding “EMBEDED AUDIO” to SDI line.
ON : Add, OFF : Not add BS SDI
(AJ-YA901P/EN)
SW2 2 OFF Not used
* See “Page number 3-8 / E-5 – E-10 of the AJ-BS900HP/EN Operating Instructions” for details of usage for each switch setting.
BS DIGITAL BOARD (VEP23516)
SW2
BS AUDIO BOARD (VEP24166)
SW5 SW6
SW1
SW9
SW7
SW8
BS FRONT BOARD (VEP20819)
SW3
SW1
BS SDI BOARD (VEP23517)
SW1