Programming Initial T1 Network Options
Quick-Start Programming
Page 72
T1 Networking - Revised April 2000
DBS-2.3/9.2-540
15. Assign each network trunk at the DBS to a Network Trunk Group. (See
Table 2-1 on page 17 and following tables.)
16. Set the DBS to four-digit numbering. After entering a
2
to select 4-digit
numbering, you will be asked to confirm the change. Press
#
to confirm.
Note: RECOMMENDED CHECK POINT
. Power off the network cabinets
for 30 seconds and power back on. After waiting approximately 1 minute for
the T1 to initialize, attempt to make a network call from each node to each
node. For instance if extension 1100 goes offhook and dials 2100, extension
2100 should ring and display
NET CALL GN
(where N = Network Trunk
Group Number) until extension 2100 is answered. When 2100 answers, both
extensions should display
NET TALK GN
. If not, recheck programming
steps 9 through 16.
Address
FF1 8# 4# 8# 4# (TRK#) (0-3)#
Options
0=Not Assigned to a Network Trunk Group
1=Network Trunk Group 1
2=Network Trunk Group 2
3=Network Trunk Group 3
Address
FF1 2# 1# 12# (0-2)#
Options
0=2 digit number plan
1=3 digit numbering plan
2=4 digit numbering plan
Notes:
The network node number must be defined (step 13 above)
before 4-digit numbering can be enabled.
Summary of Contents for DBS Section 540
